American Power Cord Precautions

1. The American power cord has the requirement of peeling the head and ironing the tin. The user and peels the head according to the user's requirements, hot tin or semi-peeling, not hot tin. Among them, stripping hot tin: functional peeling machine, stripping pliers according to the length of the order, peeling off the insulation layer, peeling should pay attention not to damage the conductive core, then apply the flux in the hot tin, and then in the tin The length required for dip. Semi-stripping: Use scissors to cut the insulation layer according to the length of the order, and do not strip the insulation layer. And pull a distance of 1~2mm at the fault, but can not strip off the insulation layer.

2. The American power cord trimmer will carefully trim the powder and burrs after injection molding. The trimming should be smooth and the surface of the plug should not be damaged.

3. When the American power cord is wound, it must be according to the length of the order. After winding the wire, use the plastic mini wire to tie it up.